What if the auto-provision process fails to fully configure my phone?
|
What if my Polycom phone finishes the auto-provisioning process but doesn't work properly or the display is not correct? This problem is a very rare occurrence where the old data refuses to be overwritten. We need to completely wipe the old configuration information. On the phone, press the Menu button Select 3. Settings Select 2. Advanced Enter the password: 456 Press Enter Select 1. Admin Settings Select 4. Reset to Default Select 1. Reset Local Config Are you sure? message appears Press Yes The phone will reformat, reboot and bring down the correct provisioning data. |
Email
PrintRelated Articles
Setting up Polycom phones not purchased through Aptela
This article is helpful for customers who did not purchase Polycom phones through Aptela. Auto-configuration automatically updates the firmware...
(No rating)
2006.09.02
Views: 12890
How do I configure my Polycom phone with a static IP address
Aptela recommends that you use DHCP for the phone's network configuration. That aside, sometimes it is necessary to use static addressing on...
2006.09.18
Views: 7185
Using Aptela Temporary Numbers During the Porting Process
If you would like to use Aptela temporary numbers during the porting process, please follow the steps below:
Verify that your Aptela account,...
(No rating)
2008.08.07
Views: 3486
Overview of the Service Setup Process
As a new customer, you deserve to know what to expect during the setup of your new service.Customer downloads and completes the attached Setup...
2009.03.05
Views: 6971
Setting up a Queue
Aptela Queues is a purchased add-on feature. If you would like to add this feature to your account, the Account Operator must submit a support...
(No rating)
2009.04.29
Views: 2161