How to Reboot your Polycom Phone
|
Manual reboot To reboot phones manually, press and hold the following keys simultaneously until a confirmation tone is heard or for about three seconds: IP 300: Volume-, Volume+, Hold and Redial IP 30x: Volume-, Volume+, Hold and Do Not Disturb IP 430: Volume-, Volume+, Hold and Messages IP 50x: Volume-, Volume+, Hold and Messages IP 60x: Volume-, Volume+, Mute and Messages Note: Holding 4, 6, 8 and * resets all parameters configured on the phone (network, server and otherwise) and then reboots. It is not just a manual reboot. (For IP 430 phones, use 1, 3, 5, 7) |
Email
PrintRelated Articles
Polycom Configuration Guide (Aptela Purchased)
Instructions to set up Aptela purchased Polycom phones are detailed in the guide to the right (see attachments box).Also, visit our YouTube...
2009.04.16
Views: 13817
Troubleshooting Polycom Phone Configuration
Most phone installation or registration issues arise when the phone's MAC Address is
not assigned to an extension or when the phone settings...
2006.09.12
Views: 5185
Polycom phone cannot obtain boot parameters
Issue: My Polycom IP Phone is in a constant state of reboot. It keeps showing the message, "Failed to get boot parameters via DHCP. xxx...
(No rating)
2006.09.24
Views: 11127
Transferring via the Polycom or Aastra 6757i CT Phone
Transferring a call using the Polycom or Aastra transfer button works on inbound calls only. Follow the below steps to transfer an inbound call...
2006.09.06
Views: 12191
Resetting the Polycom phone password if you forget it
Press 4, 6, 8, and * at the same time and the phone will ask for the ADMIN password (certain Polycom models use 1, 3, 5, 7 instead). If you've...
2006.12.21
Views: 8381