Browse by Category
  
Search  
Aptela Knowledge Base » Phones and Adapters » Polycom » Troubleshooting your Polycom phone » My Polycom phone can't connect to the network

My Polycom phone can't connect to the network

If your Polycom cannot connect there is one of two problems: firewall or phone mis-configuration. This article deal with phone mis-configuration. For Firewall troubleshooting see this article:  
http://www.aptela.com/kb/idx.php/27/0/Firewalls--Routers.html

Select Setup from the phone's menu
Verify the following Network settings:

DHCP: Enabled
DHCP Menus:
  • Timeout: 3
  • BootServer: Option 66
  • BootSrv Opt: 150
  • BootSrv Type: IP Address
  • VLAN Discovery: Disabled
  • VLAN ID Opt: 129

IP Gateway: 000.000.000.000
Server Menu:
  • Server Type: FTP
  • Server Address: ftp.aptela.com
  • Server User: Client specific
  • Server Password: Client specific

SNTP Address: 000.000.000.000
GMT Offset: 0
DNS Server: 000.000.000.000
DNS Alt: 000.000.000.000
DNS Domain: blank
CDP: Enabled
VLAN: blank

If these settings are correct and you are still not getting a network connection on the phone, please plug a PC into the PC port on the back of the phone. If the PC connects to the network then the problem is with the phone or its configuration. If the PC gets no network connection then check the following:

  • Network traffic is at your network port where the phone is plugged in.
  • The network cable is plugged into the LAN port on the phone.
  • The network cable is the one shipped with the phone.

Email    Print


How helpful was this article to you?

Related Articles

article Polycom Configuration Guide (Aptela Purchased)

Instructions to set up Aptela purchased Polycom phones are detailed in the guide to the right (see attachments box).Also, visit our YouTube...
  2009.04.16    Views: 12792   

article Troubleshooting Polycom Phone Configuration

Most phone installation or registration issues arise when the phone's MAC Address is not assigned to an extension or when the phone settings...
(No rating)  2006.09.12    Views: 4313   

article Transferring via the Polycom or Aastra 6757i CT Phone

Transferring a call using the Polycom or Aastra transfer button works on inbound calls only. Follow the below steps to transfer an inbound call...
  2006.09.06    Views: 11269   

article Polycom phone cannot obtain boot parameters

Issue:  My Polycom IP Phone is in a constant state of reboot. It keeps showing the message, "Failed to get boot parameters via DHCP. xxx...
(No rating)  2006.09.24    Views: 10276   

article Resetting the Polycom phone password if you forget it

Press 4, 6, 8, and * at the same time and the phone will ask for the ADMIN password (certain Polycom models use 1, 3, 5, 7 instead). If you've...
  2006.12.21    Views: 7636