DLink Router Configuration

Most D-Link Small Office/Home Office routers are plug-and-play.  However, there may be some models where you will have to make additional changes to the configuration in order to get the phones to make and receive calls.   If your phones do not work behind the D-Link router initially, you may need to set up port forwarding on the router.  The Aptela VoIP server may require the router to open specific ports in order for the phones to function correctly.  When a request for a certain SIP port comes in from the Aptela VoIP server, the router will route the data to the phone you specify.   To configure port forwarding on a D-Link router, you will need to access the web interface of the router.  1.  Enter the IP address of the router into a web browser and  hit the Enter key.  Note, the IP address may vary depending on your network, but default the IP may be:  192.168.0.1 2.  You will be prompted for user name & password.  The user name is:  admin.   Enter your router's password to login.  If you have not set one up before, you may not need to enter one (just leave the field blank and hit Ok).  Check your router manual for more information. 3.  Once logged in, click on the Advanced tab, and then the Applications link. 4.  Configure the following fields Click Enabled Name:  VoIP Phones Trigger Port Start Port =  5060  End Port = 50xx The end port needs to be 5060 + the number of phones you have registered.  You may want to add some extra ports in case of adding future employees.   So if you have 10 employees, you may want to use 5080 (5060 + 10 + 10 extra). Trigger Type:  UDP Public Port:  5060 Public Type:  UDP Once you are finished, press the green Apply button and the router will save the new settings with the new settings.

Email    Print

Related Articles

SonicWall Router Configuration

DEFAULT SETTINGS    Our test lab results show that the default firewall rules are sufficient in order to allow two-way communication.  The...
  2006.08.29    Views: 7744   

Linksys Router Configuration

Default Settings Our test lab results show that the default settings are sufficient in order to allow two-way communication.  The phones will...
  2006.08.29    Views: 13339   

Cisco SPA 300 and SPA 500 Series Phones - Manual Configuration

Any Cisco SPA 500 or SPA 300 series IP phone not purchased through Aptela was not pre-configured to work with Aptela. These phones will need to...
  2010.12.14    Views: 2527   

Setting up the Linksys SPA2102 ATA for auto-configuration

To set up the Linksys SPA2102 ATA for a user or a fax machine, follow the below instructions. Also, visit our YouTube video tutorial which will...
  2009.02.27    Views: 10463